PUNCH PINS (Boring Needles) for Standard Embroidery Machines

Also available:  2 pieces pack # EWPP23/2

Can be used in ANY standard Multi-Needle embroidery machine!
Design Cutouts Like Lace or Sewn Eyelets on Standard Embroidery Machines

Create beautiful, cutout patterns surrounded by embroidery without awkward and expensive boring attachments. 

Our  #EWPP23 Punch Pins (boring needles) let you use your standard embroidery machines to produce all shapes of cutout designs combined with your embroidered patterns. No need for special offset boring attachments which are not only awkward, but very expensive, too.
 
The Punch Pin is normally installed in the first or last needle bar (so you can remember where it is).  An outline is sewn around the area to be punched out to stabilize the material and backing.  Program the Punch Pin to fill in the outlined area. The designated area is then punched out, followed by the sewing of the rest of the embroidery pattern. You can even make eyelets in finished hats.

Specially shaped, sharpened, and hardened points allow for accurate, clean cuts repeatedly.

Pin diameter. 1.43mm (0.056")
Length.  30mm (1-3/16")